Piston.my

turbo engine

Three-cylinder engines in cars are nothing new; Daihatsu popularized the engine configuration in the late 1970s with its Charade and then it was widely used by Perodua. Since the 21st century began 20 years ago, manufacturers have been downsizing engines as one way to reduce fuel consumption. However, unlike those older small engines, today’s downsized engines have a lot of advanced technology to help them develop high outputs and run even more efficiently.

The HR10DET engine in the all-new Nissan Almera Turbo is a good example. It has a displacement of 1 litre but can generate up to 100 ps with 152 Nm. This is comparable to a 1.5-litre engine so the driver enjoys the benefit of a smaller displacement which will consume less fuel – without sacrificing performance, which was the case before.

Nissan HR10DET engine in Nissan Almera Turbo

Some of the features which helps the HR10DET engine, which has 3 cylinders, achieve its high output are 4 valves per cylinder for better breathing efficiency and two overhead camshafts in the cylinder head (DOHC).

Boost from turbocharger
A major contributor to the power output is the use of a turbocharger. Once found only in high-performance engines, the turbocharger is now commonly used for small engines to boost output and response. In the case of the Nissan engine, maximum torque is available between 2,400 and 4,000 rpm, a range that is frequently used in daily driving. With maximum torque available, overtaking can be done quickly and safely.

The turbocharger has an Electronic Wastegate which operates far more efficiently than a conventional mechanical wastegate. A sensor monitors compression levels and enables the wastegate to activate whenever necessary, allowing turbocharging to be maximized. As a result, turbo lag is virtually eliminated for strong acceleration when needed.

Cooling down the air
For a turbocharger to operate at its best, the air flowing through needs to be cool so it can be compressed as much as possible, maximizing the charge. For this reason, an intercooler is installed behind the front grille and effectively cools down the air.

BHPetrol RON95 Euro4M

Technology from GT-R engine
Friction robs an engine of power and engineers work hard to find ways to bring internal friction down. For the HR10DET engine, they drew on the Mirror Bore Coating technology from the legendary Nissan GT-R. Mirror Bore Coating technology can raise energy efficiency by reducing the friction significantly inside the engine.

Rather than inserting a cylinder liner, the technology uses molten iron sprayed onto the surface of the cylinder bore to form a layer of iron coating on the walls inside. This achieves a mirror-like finish that is exceptionally smooth, thereby bringing down friction levels.

Normally, the cylinder liner is 2 mm thick but with Mirror Bore Coating technology, the layer is just 0.2 mm thick, saving weight. The extremely thin layer allows better heat conduction which results in enhanced cooling performance and less engine knocking. The efficiency of the engine as a whole is improved, and fuel economy as well as engine power are enhanced.

D-Step Logic System
The powertrain of the Almera Turbo also includes a next-generation XTRONIC CVT with D-Step Logic System to improve shift feel and responsiveness. The D-Step Logic System is a computer program that uses dynamic inputs such as vehicle speed, accelerator pedal position and application speed to determine ideal gear ratios needed to provide smooth, constant acceleration.

Drivers will feel the shifting being like a conventional automatic transmission with a torque converter (which we can confirm after our short test drive) and with the flexibility and smoothness of a CVT. A Sport mode is available to gain stronger acceleration when required.

“The all-new 1-litre turbo engine is designed to meet our customers’ needs. It provides the highest level of fuel economy – up to 18.4 kms per litre – which can provide up to 650 kms on one full tank. The CO2 emission level has also significantly been reduced by 18% compared to its predecessor. making the All-New Almera Turbo even more environmentally friendly,” said Christopher Tan, Sales & Marketing Director of Edaran Tan Chong Motor.

Selected Nissan showrooms around the country are offering test-drives of the new model so you can experience for yourself the performance of the car. Visit www.almeraturbo.com.my to locate a showroom and by the way, when you take a test-drive, you could also win an Apple iPhone SE worth RM2,199.

The Volvo 240 was the Swedish carmaker’s first model to be a production ‘multi-millionaire’ and it was a major revenue-earner for the company in the 1970s. It was part of the 200 series which sold very well in America, a market that at one point accounted for over 50% of Volvo’s export sales.

Most people remember that 240 as a solid and safe car. However, it was not only in safety that this model gained a reputation as it was also one of the cars which was on the starting line of the age of powerful and efficient turbocharged engines 40 years ago. As the 245, It was also the first stationwagon with a turbocharged petrol engine.

Volvo 240 Turbo

Volvo’s engineers used their expertise with turbocharged engines, which was accumulated from 1954 when the brand’s L395 Titan truck went into mass production. Today, modular turbocharging forms the basis for all Volvo Drive-E engines in order to generate different power levels with the same cubic capacity.

The Volvo Turbo
40 years ago, there were some sportscars with turbocharged engines and such engines were also used in Formula 1 cars. But the 240 with a turbocharged petrol engine marked the beginning of a new era with the Volvo B21ET 4-cylinder petrol engine. It had a turbine that could spin at 110,000 rpm and produced up to 155 bhp from a displacement of 2.1 litres.

BHPetrol RON95 Euro4M

While a higher output usually meant higher fuel consumption, the 4-cylinder engine consumed less fuel than the bigger V6 engine in the 264. Performance-wise, a 0 to 100 km/h time of just under 9 seconds put the 245 Stationwagon briefly in pole position among the world’s fastest stationwagons.

In the USA, Volvo advertising even compared ‘The Turbo By Volvo’ with Italian supercars. What was important to Volvo was the acceleration and not the maximum speed. After all, the speed limit on US highways during that period was 55 mph (88 km/h) due to the energy crisis so Volvo did not highlight any top speed capability in its advertisements.

Volvo 240 Turbo
Advertisements for the 240 Turbo in America in the late 1970s.

Innovative technology
With around 2.7 million units sold in almost 20 years of production, the 240, introduced in 1974, became an icon of Volvo cars. Its design gave the car a recognisable identity with the massive safety bumpers.

The 240 Turbo made its debut in 1977 and the 3-year lapse was because the engine was subjected to a stress test in everyday work by Swedish police authorities. The result was so convincing that the later production version of the 240 Turbo was used by police authorities in many countries. Even Pehr Gyllenhammar, then CEO and President of Volvo, personally tested the model with its higher performance before approving start of production.

Volvo 240 Turbo

The mode of operation of the somewhat small turbocharger (for that time) was revolutionary. Because it was already boosting the charge at 1,400 rpm (just above idling speed) the turbo in the B21ET engine reached maximum boost at a low 2,600 rpm, then the wastegate valve opened at a pressure of 0.72 bar.

The idea of ​​downsizing engines in favour of maximized efficiency was also accelerated by the 240 Turbo. There was a 1.9-litre turbo 4-cylinder unit (B19ET) available for certain markets where a capacity below 2 litres was advantageous tax-wise.

Volvo 240 Turbo engine

Engine construction with racing expertise
Motorsport often drives technical developments and Volvo developed a R-Sport turbo kit for those who wanted to participate in the one-make series Volvo Turbo Cup in 1982. In the same year, the FIA introduced new regulations that made it possible for the car to be entered in the Group A touring car categories.

The specially developed 240 Turbo Evolution, produced in the required 500 units, had a larger turbocharger, a modified engine control system and water injection, an invention patented by Volvo. At the opening race of the new German Touring Car Championship (DTM) in 1984, the 330 ps racing car that became famous as ‘The Flying Brick’ took overall victory. A year later, a 240 Turbo dominated the racing series in Europe and not only secured the title in the DTM, but also in the European Touring Car Championship.

Volvo 240 Turbo

New milestones in Volvo Turbo engine development followed. The 760, launched in 1982, made its debut as the world’s most dynamic 6-cylinder turbodiesel, and the 480 which appeared 3 years later combined front-wheel drive with turbocharging.

Then came the 850 in the early 1990s and this combined 4-wheel drive with high-torque turbo power, while the 1.6-litre GTDi engines which were introduced in 2010 in the S60/V60 offered direct injection with turbocharging.

Volvo 480 Turbo
480 Turbo

Future-oriented advantages
With all current Volvo Drive powertrains, modular charging offers different power levels with the same displacement, because the compact design of the highly efficient Volvo motors allows the installation of one or more turbochargers. The fully integrated turbo system developed by Volvo is a globally unique innovation and has been patented by the company.

Volvo P1800 Cyan offers genuine ’60s driving pleasure

COVID-19

Archive

Follow us on Facebook

Follow us on YouTube